MATCH GRADE THREADED CONVERSION BARREL FOR GLOCK 23


The Brownells Match-Grade Conversion Barrel enables you to switch your .40 S&W chambered Glock® 23 to shoot 9mm Luger (9x19mm) ammo AND also improve its accuracy potential at the same time. It fits Gen1 through Gen4 variants of the Glock® 23, and will be a drop-in install on most guns. Each conversion barrel is machined from 416R stainless steel alloy to precise dimensions to ensure a tight lockup and long service life. Button-rifled with 1-10" right-hand, 6-groove rifling that is compatible with inexpensive "practice" ammo that has non-jacketed bullets. The hard Black Nitride finish resists surface wear and stops in its tracks whatever corrosion might try to challenge the stainless steel. Available threaded for (1/2"-28 tpi) to enable installation of a compensator or sound suppressor. Laser engraved with the chambering and the Glock®model it fits.

• Fits Glock® 23 Gen1 thru Gen4
• G19-compatible 9mm magazine required to complete the conversion (not included)
• Extra-strong 416R stainless steel alloy
• Matte black Nitride anti-corrosion finish
• Button-rifled 1-10" twist
• Has 1/2"-28 tpi threads

If you have an old Glock® 23 with a shot-out factory barrel, give it a new lease on life. Swap in a Brownells match-grade conversion barrel and enjoy the gentler recoil AND lower cost of 9mm ammo. Remember: to complete the conversion, you will need to add a Glock®19 compatible 9mm magazine.


DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Neither Brownells nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For genuine GLOCK, Inc. and GLOCK Ges.m.b.H. products and parts visit www.glock.com.