EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions

• Remove the rear sight*
• Install the EGW Sight Mount in the dovetail
• Tighten set screw (if applicable)
• Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty.

• This product should be installed and checked by a qualified gunsmith.
• No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

This Mount does not fit:

• Smith & Wesson M&P C.O.R.E Series (Already optics ready)
• Smith & Wesson M&P Shield EZ .380
• Smith & Wesson M&P .22 Compact
• Smith & Wesson SW9VE
• Smith & Wesson SW40VE