• Material: 7075 Aluminum
• Coating: Matte Black Hardcoat
• Overall Length: 1.811"
• Overall Width: .99"

Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw Red Dot Fitment: Trijicon RMR Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120" Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions

• Remove the rear sight*
• Install the EGW Sight Mount in the dovetail
• Tighten set screw (if applicable)
• Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trjicon RMR The flat head screws that are included with this mount require a 5/64'' allen wrench for installation.