This mount comes standard with a bevel on both sides making it ambidextrous. EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions they have published. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. EGW machines these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately). Recommend:

• 0 MOA - if shooting 0-500 yards
• 20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, EGW recommends zeroing at 200 yards. The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

This mount fits:

• Savage Model 110 Long Action Flat Rear Receiver
• Savage Model 111 Long Action Flat Rear Receiver
• Savage Model 112 Long Action Flat Rear Receiver
• Savage Model 114 Long Action Flat Rear Receiver
• Savage Model 116 Long Action Flat Rear Receiver

This mount does not fit:

Any Savage Long Action with a Round Rear Receiver