XRT Series X-Rings, bringing a whole new level of beauty and precision into an extremely rugged Picatinny platform scope mount. The X-Rings have been built from the bottom up to provide the extreme precision and accuracy that TPS rings have been known for over the last two decades. The ring bases begin from a solid billet of 7075-T6 aluminum and then machined with our unique Double-Lug Picatinny recoil shoulders from the solid billet. We have designed and engineered the Double-Lug recoil system to allow the parallelism and perpendicularity of the lugs to the ring bore to be within .0002, thereby providing repeatability that no other mount in the world with similar integrated lugs has done before. The X-Rings are specifically designed for the Mil-STD 1913 rail system. Because of the Double-Lug system, they do require two (2) accompanied cross-slots in a 1913 cross-slot configuration. The ring caps are secured with Four (4) 8-32 x 1/2″ Camcar-Textron Torx drive screws and with the same unique design that allows you to tighten the left side of the cap, then the right side without the scope rotating. The edges and corners are fully radiused, preventing snagging, and providing a beautiful appearance to your rifle.

The rings are securely attached to your rail with an oversized clamp system using Two (2) 8-32 x 1/2″ Camcar-Textron Torx screws, preventing any chance your rings will loosen or move once installed. With unparalleled precision and holding force, and sleek design, these will meet the extreme expectations of any class shooter. SPECS: 7075-T651 Aluminum Alloy, matte black, hard anodized to Mil-A-8625 standards. .700″ (17.8mm) wide. Height measured from the top of base to center of the ring. 30mm – High: .1.075″ (31.11mm).