LONG FORCING CONE CHAMBER REAMER


Double-duty reamers lengthen short chambers to modern standard or magnum lengths and cut the new long forcing cone at the same time - OR - will cut a long forcing cone without lengthening the chamber for the gunsmith seeking improved shooting performance for his customer. Flute placement, relief and angle are designed to give the best possible results on all types of barrel steel (except on chrome lined barrels, of course!). The 1½" long (approximately) forcing cone created is performance proven to give optimum results in any length chamber.


Reamers are ground exclusively for us from special, select tool steel by one of the oldest and most respected manufacturers of reamers in the United States. Plus, the hex-drive permits use of a socket and T-handle when tap handles will not operate. Lathe setup not required.

• 5.74" (14.6cm) long overall.
• 1" (2.5cm) long hex section: .5" (12.7mm) across on 12, and 16 gauge.
• 7/16" (11.1mm) across on 20 gauge.
• 3/8" (9.5mm) across on .410 (10.4mm).
• 1.5" (3.8cm) long forcing cone cutting section. 7 flutes, straight cut.